How Spray Foam Insulation San Angelo Works

Spray Foam Insulation San Angelo insulates and air seals houses, shops, barns and metal buildings in San Angelo and the towns around the Concho Valley. We spray open-cell and closed-cell foam, blow in fiberglass or cellulose, and pull out old insulation that is matted, dusty or full of rodent mess.

Every job starts in the attic. In this part of Texas the attic is where summer heat piles up and where most ductwork runs, so it tells us more about a house than any other space. We check how deep the current insulation is and how it has held up, look for gaps around wiring, plumbing, lights and the attic hatch, and note where ducts are crushed, disconnected or uninsulated. If the house has a pier-and-beam floor or a garage under living space, we look there too.

Then we put a plan on paper. Some houses need foam on the underside of the roof deck. Many do fine with sealed ceilings and a thick blanket of blown-in. Steel shops and barns usually need closed-cell foam on the metal. The quote lists each area separately so you can see what you are paying for and choose what to do first.

How we run a job

• See it first. No price until we have been in the attic and measured.
• Itemized quote. Material, thickness or depth, target R-value and cost for every area.
• Seal, then insulate. Gaps get closed before new insulation hides them.
• Work around the heat. Summer attics in San Angelo get dangerous by midday, so attic work is scheduled early.
• Protect the house. Floors and belongings are covered and the work area is closed off.
• Changes in writing. If something new turns up, we explain it and agree on it before doing it.

Call (325) 896-5239 or send the form and we will set a time to come out.